Installation; Connecting To A Computer - Sanyo PLC-SW30 Owner's Manual

Installation

Connecting to a Computer

IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
Note :
When connecting the cable, the power
cords of both the projector and the external
equipment should be disconnected from
AC outlet. Turn the projector and peripheral
equipment on before the computer is
switched on.
Cables used for connection
• VGA Cable ( HDB 15 pin )
• Audio Cable ( Mini Plug (stereo) ) ✽
• USB Cable ✽
• MAC Adapter ( For Macintosh ) ✽
✽ Not supplied.
Monitor Output Audio Output
Audio Cable
VGA Cable
(Stereo) ✽
RESET
VIDEO
S-VIDEO
COMPUTER IN /
COMPONENT IN /
AUDIO IN
COMPUTER /
AV
COMPONENT
Terminals of the Projector
USB port
If you wish to use Page ▲▼ buttons on
USB
✽
Cable
the remote control, connect USB port of
your computer to the USB socket of the
projector. (
SERVICE PORT
USB
◆ MAC ADAPTER (Not supplied)
A Macintosh adapter may be required when you use a
Macintosh computer.
Set switches as shown in the
table below depending on RES-
OLUTION MODE that you want
to use before you turn on pro-
jector and computer.
1
13" MODE (640 x 480) ON
16" MODE (832 x 624) OFF
19" MODE (1024 x 768) OFF
21" MODE (1152 x 870) ON ON
☞
P10, P38 )
✽
ON
ON DIP
1 2 3 4 5 6
OFF
2 3 4 5 6
ON OFF OFF OFF OFF
ON OFF ON OFF OFF
ON ON OFF OFF OFF
ON ON ON ON OFF OFF
15