Attaching An Electrical Sync Cord - Ikelite 6970.05 Instructions Manual

•
Ikelite DS51
•
Ikelite DS125 above serial # 5000
•
Ikelite DS160, DS161
•
Ikelite DS200 above serial # 7163
Flash exposure compensation may be added or subtracted using the
camera's menu settings.
Strobes from SEA&SEA, INON, and other manufacturers may be
attached by electrical sync cord. These strobes are not capable of
powering the TTL circuitry built into this housing. Non-Ikelite strobes
must be used in manual power modes.

Attaching an Electrical Sync Cord

1. Remove connector protectors and bulkhead caps from each
connection.
2. Apply a very thin, even layer of lubricant on all threads, sealing
surfaces, and the exposed portion of the plug o-ring. Do not allow
lubricant to get into the pins and receptacles of the plug or
bulkheads.
Bulkhead
cap
Bulkhead
Retaining
ring
19