Setting Up Your Camera
Pre-Installation Checklist
1. Insert a fully charged camera battery.
2. Insert a properly formatted memory card.
3. Remove any attached lanyard or neck strap.
4. Remove the camera's eyecup. Failure to remove the eyecup prior
to installation will prevent the rear controls from operating properly.
Camera Settings
•
Touch control
Set
•
AF-assist beam firing
Set
•
Flash Firing
Set
•
Shutter Synchronization
Set
(default) when using an external strobe.
•
Red-Eye Reduction
Set
strobe.
Camera Settings Display
The Quick Control button can be used to view and change a variety
of camera settings including aperture, shutter speed, ISO, and white
balance (depending on shooting mode).
In the camera's menu, set
Press the Quick Control button, then use the up/down/left/right cursor
buttons to select the desired function. Turn the main dial to change the
setting.
to "Disable."
to "Disable."
to "Enable" if using an external strobe.
to "First-curtain synchronization"
to "Disable" when using an external
Shooting screen
to "Standard."
11