Proxxon Micromot 230/E Manual page 9

of the speed:
Small milling cutters / pins = high speed,
large milling cutters / pins = low speed.
1. Activate the device with the switch 1 (Fig. 1) and
set the right speed for the work on the knob 2.
2. Fig. 4 illustrates two typical ways of holding the
MICROMOT 230/E. Ensure that you hold the
device fi rmly during work to enable controlled
guiding of the rotating operational tool. Avoid
covering the ventilation slots during this! In the
event of overheating, deactivate the device and
allow to cool for a few minutes.
5.4 Maintenance, cleaning and care
Caution:
Disconnect the mains plug prior to every
adjustment, maintenance measure or repair!
Note:
Every device is dirtied by dust when working with
wood. Cleaning is therefore essential. To ensure
a long service life, however, the machine should
be cleaned with a soft cloth or brush after each
used.
Mild soap or another suitable cleaning agent
may be used in this context. Solvents or cleaning
agents containing alcohol (e.g. petrol, cleaning
alcohols, etc.) should be avoided, since these can
attack plastic casings.
Always keep the apertures required for cooling
the motor free of dust and dirt.
Accessories:
For more detailed information on accessories,
please request our device catalogue from
the address specifi ed on the last page in the
warranty information.
Please note in general:
Proxxon bits and cutters have been designed
to work with our machines, which makes them
optimal for their use.
We will not assume any liability whatsoever
for the safe and proper function of our devices
- 18 -
when using third-party bits and cutters!
Please note:
The mains power input may only be replaced by
our Proxxon Service Department or a qualifi ed
specialist!
5.5 Disposal:
Please do not dispose of this machine in
household waste! The device contains reusable
materials which can be recycled. If you have
any questions about this, please contact your
local disposal company or other appropriate
local facilities.