Cisco UCS C220 M4 Maintaining The Server page 56

Installing or Replacing Server Components
To resolve this issue, disable the Option ROMs that are not needed for system booting. The BIOS Setup
Utility provides the setup options to enable or disable the Option ROMs at the PCIe slot level for the
PCIe expansion slots and at the port level for the onboard NICs. These options can be found in the BIOS
Setup Utility Advanced > PCI Configuration page.
•
•
Resolving Insufficient 16-Bit I/O Space
The system has only 64 KB of legacy 16-bit I/O resources available. This 64 KB of I/O space is divided
between the CPUs in the system because the PCIe controller is integrated into the CPUs. This server
BIOS has the capability to dynamically detect the 16-bit I/O resource requirement for each CPU and then
balance the 16-bit I/O resource allocation between the CPUs during the PCI bus enumeration phase of
the BIOS POST.
When a large number of PCIe cards are installed in the system, the system BIOS might not have
sufficient I/O space for some PCIe devices. If the system BIOS is not able to allocate the required I/O
resources for any PCIe devices, the following symptoms have been observed:
•
•
•
•
•
•
To work around this problem, rebalance the 16-bit I/O load using the following methods:
1.
2.
Cisco UCS C220 M4 Server Installation and Service Guide
3-56
Guidelines for RAID controller booting
If the server is configured to boot primarily from RAID storage, make sure that the option ROMs
for the slots where your RAID controllers installed are enabled in the BIOS, depending on your
RAID controller configuration.
If the RAID controller does not appear in the system boot order even with the option ROMs for those
slots enabled, the RAID controller option ROM might not have sufficient memory space to execute.
In that case, disable other option ROMs that are not needed for the system configuration to free up
some memory space for the RAID controller option ROM.
Guidelines for onboard NIC PXE booting
If the system is configured to primarily perform PXE boot from onboard NICs, make sure that the
option ROMs for the onboard NICs to be booted from are enabled in the BIOS Setup Utility. Disable
other option ROMs that are not needed to create sufficient memory space for the onboard NICs.
The system might get stuck in an infinite reset loop.
The BIOS might appear to hang while initializing PCIe devices.
The PCIe option ROMs might take excessive time to complete, which appears to lock up the system.
PCIe boot devices might not be accessible from the BIOS.
PCIe option ROMs might report initialization errors. These errors are seen before the BIOS passes
control to the operating system.
The keyboard might not work.
Physically remove any unused PCIe cards.
If the system has one or more Cisco virtual interface cards (VICs) installed, disable the PXE boot
on the VICs that are not required for the system boot configuration by using the Network Adapters
page in the Cisco IMC Web UI to free up some 16-bit I/O resources. Each VIC uses a minimum 16
KB of 16-bit I/O resource, so disabling PXE boot on Cisco VICs would free up some 16-bit I/O
resources that can be used for other PCIe cards that are installed in the system.
Chapter 3 Maintaining the Server
OL-32473-01