Cisco UCS C220 M4 Maintaining The Server page 43

Chapter 3 Maintaining the Server
If this is a first-time installation of your TMM, you must also install a supercap power module (SCPM).
Note
The SCPM cable attaches to a connector on the TMM. See
(RAID Backup), page
Connect the cable from the supercap power module (RAID battery) to the connector on the TMM
a.
(see
With the riser upside down, align the connector on the card with the socket on the riser. The end of
b.
the card should also go into the guide channel on the riser bracket (see
Carefully push on both corners of the card until it is seated in the socket.
c.
Tighten the single thumbscrew that secures the card to the riser bracket.
d.
Return the riser to the server:
Step 7
Align the connector on the riser with the socket on the motherboard. At the same time, align the two
a.
slots on the back side of the bracket with the two pegs on the inner chassis wall.
Push down gently to engage the riser connector with the motherboard socket. The metal riser bracket
b.
must also engage the two pegs that secure it to the chassis wall.
Reconnect the SAS cable to its connector on the RAID controller card.
Step 8
Replace the top cover.
Step 9
Replace the server in the rack, replace cables, and then power on the server by pressing the Power button.
Step 10
OL-32473-01
3-45.
Figure 3-22).
Installing or Replacing Server Components
Replacing the Supercap Power Module
Cisco UCS C220 M4 Server Installation and Service Guide
Figure 3-21).
3-43