Safety Precaution; Introduction Of Product; Name Of Parts - Midea FP-90LST060GMTL-N Service Manual

SAFETY PRECAUTION

2. INTRODUCTION OF PRODUCTS

2.1 Name of parts

Control panel
Wash cover
Frame
Pulsator
Base
*The drawing above is based on the actual washer.
Drain hose
(For upper drain only)
Cabinet
Power plug
Drain hose
(For lower drain only)
-3-
3.TROUBLE SHOOTING
3.1 Malfuction and solution
Symptom
Possible reason
a. Laundry is much more than rated
washing capacity.
b. pulsator is tangled with clothes or
blocked by things like coins.
c. V-belt loose, broken or fall from
1. Unusual
the strap wheel.
sound when
d. Pulley broken or pulley screw is
washing or
loose .
wash weakly
e. Capacitor failure.
(motor with
sound)
a. Power supply is cut off or poor
contact of plug and socket.
b. Voltage is too low.
c. Wash timer is in poor contact or
faulted.
d. Fuse is burned.
2. Can not wash e. Wash motor failure.
(motor does
not rotate)
a. Conductive wire or alive parts in
the machine contacts with metal
cabinet.
b. Bad earth wire.
c. 2 power lines of the power supply.
d. Weak insulation strength of motor
3. Electric e. Insulation layer of wire harness is
leakage broken .
Solution
a. Reduce the laundry till the
pulsator can rotate normally.
b. Take off plug, remove the
pulsator and take out the
tangled clothes or other things.
c. Replace v-belt or reload the
v-belt.
d. Replace the pulley or tight the
pulley locking screw.
e. Replace the capacitor.
a. Check the power supply and
adjust the plug to insure good
contact.
b. Do not use the washing
machine until the voltage rise to
rated voltage.
c. Check the wire harness or
replace the wash timer.
d. Replace the fuse.
e. Replace the wash motor.
a. Check wire connecting in the
machine.
b. Check the earth wire.
c. Examine and replace the power
supply.
d. Replace the motor.
e. Examine the wire harness and
bind up the broken wire.
-4-