3.TROUBLE SHOOTING
3. No drain or unsmooth drain
Can not drain
Y
for lower drain function only
N
Whether the drain
hose is put down
Y
for upper drain function only
N
Whether the drain
hose is laid properly
Y
Whether the drain
N
hose at the side of
wash tub is blocked
Y
Whether the wash-
N
drain selection switch is
not in "drain"position
Y
N
Whether the drain
belt is well
Y
N
Whether the drain
belt is on the switch
for upper drain function only
Y
N
Whether the drain
pump is well
Put down the drain hose
The drain hose should be
placed 86cm-100cm from
the bottom of the ground
Dismantle the pulsator
and take out the blocks
in the water drain hose
Turn the switch to "drain"
position
Replace the drain belt
Hang the drain
belt onto the switch
Replace the drain pump
-7-
4.DISMANTLING WAYS OF MAIN PARTS
Operation step
1. Remove the knobs
a.Take out the knobs directly
because knobs are inserted
into the control panel.
b. If it is difficult to take knobs out,
a straight screwdriver wrapped
with cloth can be used for help.
2. Remove the control panel
a
. Take down the back cover by
loosen-ing off the screws.
b. Take down the plastic bag by
cutting off the nylon clip. Take
down all wire nut with a plier
and make all wire clamps loose.
and then unfasten the drain belt
connector.
c. Screw off the screws on the
control panel.
d. The control panel can be lifted
and removed.
3. Remove the wash cover
a
. Keep the wash cover open and
draw out the wash cover with
the help of a screw-driver.
Picture
a.
a.
c
.
a.
-8-
b.
b.
d.