Advertisement
Signamax Connectivity Systems
The Port Status LEDs
Functional Description
Meets NEMA TS1/TS2 Environmental requirements such as temperature, shock, and vibration for traffic control
•
equipment.
Meets IEC61000-6-2 EMC Generic Standard Immunity for industrial environment.
•
Support 802.3/802.3u/802.3x. Auto-negotiation: 10/100Mbps, Full/half-duplex; Auto MDI/MDIX.
•
100BaseFX: Multi mode SC, ST, VF-45, or MT-RJ type; Single mode SC or ST type; WDM Single mode SC type.
•
Support 2K MAC addresses. Provides 96K bytes memory buffer.
•
Alarms for power failure by relay output.
•
Operating voltage and Max. current consumption: 12VDC @ 0.99A, 24VDC @ 0.55A. Power consumption: 13.2W Max.
•
Power Supply: Redundant DC Terminal Block power inputs or 12VDC DC JACK with 124-240VAC external power supply.
•
Operating temperature ranges from -34
•
Supports Din-rail or panel mounting installation.
•
Assembly, Startup, and Dismantling
Assembly: Place the switch on the DIN rail from above using the slot. Push the front of the switch toward the mounting
•
surface until it audibly snaps into place.
Startup: Connect the supply voltage to start up the switch via the terminal block (or DC JACK).
•
Dismantling: Pull out the lower edge and then remove the switch from the DIN rail.
•
www.signamax-us.com
LED
10/100TX or 100FX
LNK/ACT
(Green)
100
(Yellow)
℃
to 74
℃
.
2
State
Indication
A valid network connection established.
Steady
LNK stands for LINK.
Transmitting or receiving data.
Flashing
ACT stands for ACTIVITY.
Light solid yellow for a port transferring
Steady
at 100Mbps.
The port is transferring at 10Mbps If this
Off
LED is dark.
www.signamax-eu.com
065-7408x Series
Advertisement
