Operation - ADJ ENTOUR FAZE User Instructions

Entour Faze
When this function is activated the machine will detect if any
fluid is in the reservoir. If there is no fluid the machine will not go
into work mode. When activated the machine will stop working
when the fluid runs out.
1. Press the MODE button until "FXXX" is displayed. "XXX"
represents the current setting.
2. To activate the fluid inspection function, press the UP or
DOWN buttons so that "F001" is displayed.
3. To deactivate the fluid inspection function, press the UP or
Down buttons so that "F000" is displayed.
4. If there is no fluid in the tank, "no F" will be displayed.
Entour Faze
START UP:
1. Plug the power cord into a matching power source and put
the power switch into the "On" position. The current software
version will be displayed.
2. 2 Seconds after power is applied the unit
will begin to warm up.
3. After the machine has fully heated up, the last function before power
was shut off will be displayed. Follow the directions on the next few
pages for the different operating modes.
ADJ Products, LLC - www.adj.com - Entour Faze Instruction Manual Page 10
Fluid Inspection On/Off
Start Up
Entour Faze
MANUAL FOGGING:
1. Put the MANUAL button in the "On" postion. The output can
be adjusted using the UP or DOWN buttons. To stop manual
fogging put the MANUAL button into the "Off" position.
2. When you stop manual fogging the display will read "PICL".
This process is cleaning the excess fluid out of the pump and
tubing. After this process is done the display will show
"Stby".
NOTE: Please let this process run its course before shutting
off the faze machine.
ADJ Products, LLC - www.adj.com - Entour Faze Instruction Manual Page 11

Operation