Pattern sheet (supplied)
Mount the camera by aligning the triangular marks (▲), then rotate the camera in the arrow
(D) direction.
•
Make sure the camera is securely mounted.
Open the side cover and tighten the fall-prevention screw (E) using the supplied hexagonal
wrench (F).
•
When fi nished, make sure to put the cover back.
•
The surface of the camera can be hot during operation, but it is not a malfunction.
When you touch the heated portion of the camera for a long time during installation, adjustment or
dismounting, you may get a low-temperature burn.
•
SD card may be hot immediately after use. When you remove a SD card from the camera, be
absolutely sure to turn it off and wait until it is completely cooled down.
Ceiling
(F)
(E)
10
Installation
(D)
(D)