Changing.the.battery; Power.failure - Sanyo CLT-D6620(WH) Instruction Manual

CHANGING.THE.BATTERY

Battery.replacement.and.handling
When the operating time becomes short even after a battery is recharged,
please replace the battery.
With normal usage, your battery should last approximately one year.
For a replacement battery, please contact your place of purchase or fill out and
mail the enlosed form.
CAUTION:
• Use only the specified battery pack type (Ni-MH 3.6V, 650mAh).
• Do not remove the battery from the handset to charge it.
• Never throw the battery into a fire, disassemble it, or heat it.
• Do not remove or damage the battery casing.
• Remove battery if storing the phone for over 30 days.
Make.sure.the.telephone.is.off.before.you.replace.the.battery.
1. Slide off the battery compartment cover.
2. Remove the battery pack from the compartment.
3. Insert the new battery pack according to the polarity engraved.
NOTE: Please refer to the TO INSTALL A REPLACEMENT BATTERY PACK
section Page .
4. Put the battery compartment cover back on.
5. Place handset on the base to charge for 15 hours.
Charge the handset battery for 15 continuous hours prior to first use. The initial
battery charge is important for best performance.
CAUTION:.To reduce the risk of fire or personal injury, use a NI-MH 3.6 V,
650mAh battery.
Replacement part number :

POWER.FAILURE

When power is off, you will not be able to make or receive calls with the
telephone.
3SN-AAA
35