Multi.handsets.functions; Registration - Sanyo CLT-D6620(WH) Instruction Manual

MULTI.HANDSETS.FUNCTIONS

If you have more than one handset, you can enjoy an intercom call between
handsets. You can also establish a conference call (between two handsets and
outside).

Registration

The handset and base unit are factory pre-registered with each other. Therefore,
the unit should be in full working order out of the box. When you purchase an
additional handset, you have to register it to the base unit in order to make and
answer calls.
You can register up to 3 more handsets to make and answer calls via the same
base unit. Handsets are numbered 1 to 4.
If your handset is not registered to the base "NOT REGISTERED" will display on
the handset. The handset must first be registered to the base to be used.
To.register.a.new.handset:
1. Touch and select the SECURITY SET menu and then the
REGISTRATION submenu.
2. Use .or. .to select the base number you wish to register to.
3. Touch .to confirm.
4. Enter the 4 digit PIN code (default 0000) and touch
message: 'REGISTERING'.
5. Press and hold the PAGE key on the base until the Charge/In use LED
flashes.
6. 'REGISTRATION ACCEPTED' indicates that handset is registered.
'RETRY?' indicates that registration has failed. Touch
quit.
To.select.a.base.unit.on.your.handset:
Your telephone supports up to 4 base units. After you register 1 handset to 4
base units, bases are numbered 1 to 4, you may select which one to use.
1. Touch and select the SECURITY SET menu and then the SELECT
BASE submenu.
2. Use or to select the base number or 'AUTO' (automatically selects
the nearest base).
3. Touch .to confirm.
4. 'ACCEPTED' indicates that base has been selected. 'RETRY?' indicates
that selection has failed. Touch
, you will see the
to retry or to quit.
30
to retry or to