1. OPERATING INSTRUCTIONS
1-1. FRONT PANEL CONTROLS
1. Monitor Selector Switch (VIDEO A/B)
Turn this Monitor selector switch A position for a
signal fed through the rear panel VIDEO A
connectors.
Then, turn this Monitor selector switch B posi-
tion for a signal fed through the rear panel
VIDEO B connectors.
2. Contrast Control (
Turn to adjust picture contrast according to your
requirement.
3. Brightness Control (
Turn to adjust picture brightness according to
your requirement.
4. Power Indicator
Lights when the power is on.
Lit: When the power is on.
Unlit: When the power is off.
5. Power Switch (POWER)
Press this switch to turn the power on or off.
1-2. REAR PANEL CONTROLS & CONNECTION
1. AC input socket (AC INPUT)
Connect the AC power cord (supplied) securely
to this socket and to a wall outlet.
2. Video input terminals (VIDEO IN)
These terminals are used to input a video signal
source to this monitor.
Connect to the video output of a VCR or an-
other monitor (for loop through connection) or to
a video camera.
3. Video output terminals (VIDEO OUT)
These terminals are used to output a video
signal for this monitor.
Loop-through output of the video in BNC
connector, then connect to the video input of
another monitor or a VCR.
4. Termination Switch (HI/75
Select the input impedance (HI/75 ohm).
When using only one monitor, turn the termina-
tion switch to the 75 ohm position. When using
more than one monitor, set all of the termination
switch to the monitors to the HI position.
CONTRAST)
BIRGHT)
Ω
(Lo))
However, the last monitor termination switch
should be the 75 ohm position for proper line
termination.
6. Sub-brightness control (SUB-BRI)
Turn to adjust picture brightness.
7. Vertical Size control (V-SIZE)
Turn to adjust picture vertical size of the picture.
8. Vertical hold control (V-HOLD)
If the picture is scrolling up or down on the
screen, turn this control until there is a single
steady picture.
– 5 –
2
3
4
5
1
Fig. 3