Installation And Setup - Clearaudio Absolute phono inside User Manual

User manual / Bedienungsanleitung

1. Installation and setup

Before you start, make sure that the tonearm is correctly installed on your turntable.
To proceed with installation and set-up, please see the rear panel of your Clearaudio
phono inside.
Rear view:
2
Pic. 1: Rear view
Please proceed as follows:
1. Connect the tonearm ground wire to the "GND" terminal.
2. Connect the tonearm to the input marked with "phono in R / phono in L". You can use either
RCA or XLR inputs.
To avoid hum problems by using the RCA Phono input, please make sure that the RCA or XLR
plugs and the tonearm ground wire are securely connected.
3. Plug the XLR output cable into the XLR output sockets and connect them to your linestage
preamplifier.
4. Connect the power supply provided, to the socket marked "DC in" on the
inside
main RIAA unit, then connect this power supply to your mains power supply and switch
the button on "I".
5. With "DIMMER" you can adjust the light intensity of the blue LED-Ring on the front side.
Important: Please note that you should use only the Clearaudio power supply provided.
Made in Germany
1
3 3
4
4
5
2
absolute
absolute phono
3