Blockage Related - Pelpro PP70 Owner's Manual

Troubleshooting

Blockage Related

Black soot on outside of house
• Confirm exhaust path is clean and clear (Zone 1 and 3)
- Adjust air/fuel ratio using trim adjustment dial
(See page 23 for trim adjustment instructions)
• Ensure termination cap has at least 18" clearance to
reduce the effects of soot blow-back on home exterior
(ie. siding)—if not able, refer to page 10 for alternate
installation options
Rumbling/whistling noise during operation
• Confirm exhaust path is clean and clear (Zone 1 & 3)
- Adjust air/fuel ratio using trim adjustment dial (See page 18 for trim adjustment instructions)
Stove will not light
• Confirm firebox is clean and clear (Zone 1)
- Igniter is getting hot (glows orange)
• Inspect Stove body (Zone 2)
- Confirm fuel is in hopper, close lid securely
- Remove right side panel to access and confirm vacuum switch is clear and
connected at both ends
- Confirm all exhaust blower connections ........... secure
- Confirm the feed assembly and motor are clean and clear of debris
• Confirm exhaust path is clean and clear (Zone 3)
30 PelPro Pellet Stove • 7103-171C • 11/1/18
Zone Zone
1 1
Zone Zone
2 2
pelprostoves.com