Pelpro PP70 Owner's Manual page 13

Installing Your Stove
5
• Install pellet venting through wall and connect vent/pipe to Stove
• Some venting manufacturers offer pellet Stove adapters for their
venting for easier installation
• Seal all pipe joints using high-temp silicone (500°+)
• Secure exhaust venting system to the Stove with at least 3 screws or
rivets per the pipe manufacturer's instructions. Also secure all connector
pipe joints with at least 3 screws through each joint.
• Install termination cap
• Confirm all required Stove clearances to combustibles
Pro Tip
Installing a clean-out "T" (sold separately) to the rear of your Stove, when venting
vertically can save time during cleaning.
Install outside air kit (included)
6
For optimal performance, PelPro recommends the outside air kit for
all installations. Outside air kit is required for all mobile/manufactured
home installations.
Install through wall B
• Maintain clearances from exhaust
• Remove knock out in the rear of Stove
- Attach flex pipe to outside air connection
on Stove
- Use hose clamp
- Route tube outside the structure
- Attach cap
- Secure to outside wall with appropriate fasteners
Take a Break
Inspect your work:
_____ Confirm clearances to combustibles are maintained
_____ Pipe joints are secure and properly sealed
_____ Outside air kit installed properly
_____ Confirm termination clearances
pelprostoves.com PelPro Pellet Stove • 7103-171C • 11/1/18
A
A
B
CAUTION!
Never draw outside combustion
air from:
• Wall, floor or ceiling cavity
• Enclosed space such as an
attic, garage or crawl space.
13