Using The Stand; Inserting And Removing The Ultrasound System - FujiFilm SonoSite Edge User Manual

Using the stand

To raise or lower the system platform
1 Make sure that the area above the platform is clear.
2 Facing the back of the stand, turn the height-adjustment lever counter-clockwise.
The pole may rise automatically from the column.
3 Raise or lower the pole to the desired height, and then tighten the lever.
To tighten the lever, turn it clockwise.
If lowering the pole, avoid grasping its base. Skin could get caught and pinched in the gap.
4 If you want to reposition the lever (for example, parallel to the pole), pull the lever out, turn it to the desired
position, and release.
To lock or unlock a wheel

Push the locking lever on the wheel:
Push down to lock.
Push up to unlock.

Inserting and removing the ultrasound system

To insert the ultrasound system
1 Rotate system latches outward.
2 Place the ultrasound system on the system platform, ensuring that the transducer cable is positioned
between the handles of the stand.
3 Secure by rotating the system latches inward.
To remove the ultrasound system
1 Disconnect any cords, cables, or TTC attached to the system.
2 Rotate latches outward.
3 Lift the ultrasound system.
4 Using the stand