Programmed Play; Random Play - Sanyo CDP-244 Instruction Manual

PROGRAMMED PLAY

The tracks on the disc can be programmed
for play in any order. (Up to 22 tracks can
be programmed.)
During programming, " " flashes in
PROG
the display.
Ê Press the PROGRAM button once
during play or in stop mode, "
PROG
flashes in the display.
Ë Press the
or buttons to select
the first track to be programmed.
Ì Press the PROGRAM button. The first
track is now stored in memory. The
program number changes to "
"
Í
Repeat steps 2 and 3 to program
additional tracks.
Î
After programming is finished, press the
button.
i
" " stops flashing and programmed
PROG
play begins.
i
The player stops automatically after all
programmed tracks have been played.
The programmed tracks are stored in
memory until the disc compartment is
opened or power is turned off. To play
the same program again, press the
PROGRAM button to display"
then press the button.
12
1. SINGLE TRACK REPEAT
Press the P-MODE button once during play,
02 1
". " " appears in the display.
This plays the song over until you press
the button.
2. ALL TRACKS REPEAT
Press the P-MODE button twice during play ,
" ALL " appears in the display .
All songs will keep playing in sequence and
when finished, they will start over again
until you press the
3. A B TRACKS REPEAT
Press the P-MODE button three times
during play , "
display . Press PLAY/PAUSE, "B" appears
and plays the tracks from A to B
continuously until you press the
Ê
Press the P-MODE button four times
in stop mode or during play.
", Ë
PROG
" INTRO "appears in the display. Press
the or
Ê Press the P-MODE button five times
during play.
SINGLE/ALL/A B TRACKS REPEAT
button.
A " appears in the
button.
INTROSCAN PLAY
button.

RANDOM PLAY

Ë "
" appears in the display.
Press
will be played once in random order.
13
A
or , all tracks on the disc