Download  Print this page

Power Supply - Sanyo CDP-244 Instruction Manual

Personal cd player
Hide thumbs

Advertisement

POWER SUPPLY

Plug one end of the AC adapter into the
DC 4.5V jack, then plug the other end
into an AC wall outlet.
Precautions on using the AC Adapter.
Ê
Do not touch the AC adapter with wet
hands. Doing so is dangerous, as this
could result in an electrical shock.
Ë
If the AC adapter is connected when
the batteries are installed, the power
supply automatically switches to the
AC power source and the batteries are
disconnected.
ALKALINE BATTERY INSTALLATION
Insert two AA batteries (not supplied) into
the battery compartment on the bottom of
the unit. Be sure to observe the proper
polarity (the"+" and" - " signs) as
indicated inside the battery compartment.
NOTE ON ALKALINE BATTERIES
Ê
When replacing the alkaline batteries,
use two new batteries of the same
type. Do not mix a used battery with a
new one or mix different types of
batteries.
Ë
When
inserting
the
batteries,
mistakenly inserting even one with
improper polarity will cause leakage.
Ì
Never charge, heat, disassemble, or
throw batteries into a fire.
REMEMBER
Ê
If the symbol "
" flashes in the
display, your batteries are weak.
Replace them or use the AC adapter
cigarette lighter adapter (CDP-244CRB
only).
Ë
If the display is blank
no numbers
show when PLAY/PAUSE button
pushed, the batteries are dead.
Replace them, or use AC adapter.
(Also check if you inserted the
batteries according to the + and - as
IMPORTANT NOTE:
Spent or discharged batteries must be
recycled or disposed of properly in
compliance with all applicable laws. For
detailed information, contact your local
solid waste authority.
4
CAR KIT ADAPTER (FOR CDP-244CR ONLY)
i
The supplied cigarette lighter adapter is designed for use with vehicles that have a
12V, negative ground electrical system.
Most vehicles have this type of electrical system, but if you are unsure about the
i
system in your vehicle, contact the vehicle dealer.
CIGARETTE LIGHTER ADAPTER (FOR
CDP-244CRB)
Plug one end of the cigarette lighter
adapter into the [DC IN 4.5V], then plug
the other end into the cigarette lighter
jack.
or
is
DC IN 4.5V
Caution on the cigarette lighter adapter.
i
Use this unit only with the supplied
cigarette lighter adapter. Use with
other cigarette lighter adapters could
damage the unit.
When the inside of the cigarette
i
lighter jack is dirty with ashes or
dust, the plug section may become
hot due to poor contact. Be sure to
clean the cigarette lighter jack before
use.
After use, disconnect the cigarette
i
lighter adapter plugs from both this
unit and the cigarette lighter jack.
The cigarette lighter adapter may
i
cause interference with reception
from the car radio or another radio
inside the vehicle. If this is the case,
disconnect the cigarette lighter
adapter from the cigarette lighter
jack, or use the radio at a distance
from the cigarette lighter adapter.
5

Advertisement

loading

  Related Manuals for Sanyo CDP-244

This manual is also suitable for:

Cdp-244crb