Advertisement
Cable Connections
P3
P6
P1
P2
P7
P4
P5
P8
1. At one end of the connecting cable, strip back the cable jacket 30 mm (1.18 in.) to expose the shield and twisted wire pairs. Then strip
back the cable's shield 24 mm (0.94 in.) to expose the twisted wire pairs. Remove 4 mm (0.16 in.) of insulation from the wires of each
twisted pair. Then connect the stripped wires of each twisted pair to their corresponding terminals shown in
Table 1: Cable Wire Connections
Integral Cable of Terminal Adapter
MiniDIN Plug
Connected to . . .
Pin 1
Terminal 1
Pin 6
Terminal 2
Pin 3
Terminal 3
Pin 4
Terminal 4
Pin 5
Terminal 7
Pin 8
Terminal 8
Pin 2
Terminal 6
Pin 7
Terminal 5
Shell
Shield clamp (A)
(1)
Twisted pair wire colors for the 100 meter cable supplied with the Full Kit (Catalog # 1202-CBL-KIT-100M).
(2)
Twisted pair wire colors for the Quabbin cable (p/n 2906) that is recommended when using the Adapter-Only Kit (Catalog # 1202-TB-KIT-SET).
Important: Cable wire colors are subject to change at any time. If the connecting cable wire colors are different than those listed above,
make sure that each twisted pair is terminated to the same terminal numbers on both ends of the cable.
2. Make sure that the connecting cable's shield is tightly secured under the cable shield clamp (A). If a foil shield is used (Quabbin cable),
the blue side of the foil shield is non-conductive. In this case, fold back the foil to expose the silver side of the foil to the shield clamp
before installing.
3. Tightly secure the connecting cable's outer jacket under the cable strain relief clamp (B).
4. The terminal adapter's two mounting holes (C) can be used to secure the adapter to a flat surface. Use #8 screws (not supplied) of an
appropriate length for the application.
5. Connect the other end of the connecting cable to the second terminal adapter. Repeat steps 1 through 4.
Publication 1202-IN001B-EN-P – May 2004
Supersedes 1202-IN001A-EN-P, September 2003
Male Connector
Cable in Full Kit
Black
Twisted Pair
Green
Red
Twisted Pair
Orange
Yellow
Twisted Pair
White
Brown
Twisted Pair
Blue
Shield
—
approx. 0.3 m (12 in.)
5 6
7 8
1
4
3
2
Connecting Cable Wire Colors
(1)
Quabbin Cable
White/Green
Twisted Pair
Green
White/Orange
Twisted Pair
Orange
Brown
Twisted Pair
White/Brown
White/Blue
Twisted Pair
Blue
Shield
—
A
(Cable Shield Clamp)
Connecting Cable
(6.2 mm opening in adapter housing)
B
(Cable Strain Relief Clamp)
Table
1:
(2)
Copyright © 2004 Rockwell Automation. All rights reserved. Printed in China.
(Adapter
C
Mounting
Holes)
P/N 319926-P02
Advertisement
