Whirlpool AWD60A Service Manual page 15

TROUBLE SHOOTING
1. The dryer does not start.
The power supply plug is
not fully inserted into the
power point.
N
The local circuit is out of
power.
N
Programme knob on OFF.
N
The Start/Pause button
has not been pressed.
N
Disconnect the power and
open the top board, check
if the connector is OK.
Y
Check if the PCB is OK.
Tumble Dryer
Y
Y
Y
Y
N
N
Page 13
Model:AWD60A
Insert the power plug into an
appropriate power point to
turn on the power.
Wait until the local circuit is
put on. Try to start the dryer
again.
Turn programme knob to
choose the drying programme.
Press the Start/Pause button.
Check the connector and
connect it again.
Replace with a new PCB, if
required.