Table of Contents
Advertisement
Setting up the Interfaces of the Gateway
Setting up the WAN Interface
SRP 521 VoIP Gateway Administration Guide
REVIEW DRAFT — CISCO CONFIDENTIAL
Field
Carrier
Access Point Name
(APN)
Dial Number
User Name/
Password
SIM PIN
Server Name
Authentication
Service Type
Connection Recovery
An Internet connection can be established via the WAN port or a wireless modem
plugged into the USB port. While both Ethernet and USB interfaces may be
connected, only one of them can be used to establish a link at a time. Whenever
the Internet connection fails, the gateway automatically attempts to bring up
Description
The mobile network service provider for the Internet
connection. This setting is required when you are using
HSDPA/UMTS/GPRS Internet service. Select the card
issue country from the first drop-down menu list, then
select the card issue provider from the second drop-
down list.
The Internet network to which the mobile device is
connecting to. Enter the access point name provided by
your mobile network service provider.
The dial number for the Internet connection. Enter the
Dial Number provided by your mobile network service
provider.
Enter the user name and password provided by your
mobile network service provider.
The PIN code associated with your SIM card. Enter your
SIM PIN number here.
The name of the server for the Internet connection.
The type of authentication used by your service
provider. Select your authentication type, if you do not
know which type to use, use the default setting, Auto.
Select the most commonly available type of mobile data
service connection based on your area service signal. If
your location supports only one mobile data service,
you may set up for enhance build up connection. The
first selection will always search for HSPDA/3G/UMTS
service or switch to GPRS automatically only when it is
available.
3
19
Advertisement
Table of Contents
