Calibration Parameters Summary And Defaults - Mantracourt DSC User Manual

Calibration Parameters Summary and Defaults

The various control parameters are listed for each stage.
This also includes the compensation parameters, not covered in this chapter, but shown in the flow diagram
The 'default' values shown set the device back to its nominal default calibration (mV/V)
Cell Control Defaults
Command Action
FFLV Filter dynamic level
FFST Filter Steps (max)
NMMV Nominal 2.5mV/V
RATE Rate 10Hz
CGAI basic cell gain
COFS basic cell offset
CTN number of temp points
CT1..5 temp points (Deg C)
CTO1..5 offset adjusts
CTG1..5 gain adjusts
CRAW min limit
CMIN
CMAX CRAW max limit
CLN number of linearity points
CLX1..7 linearity raw-value points
CLK1..7 linearity adjusts
System Control Defaults
Command Action
SGAI basic gain
SOFS basic offset
SMIN SRAW min limit
SMAX SRAW max limit
SZ output zero offset
Micron Meters DCell & DSC User Manual
Default Values
0.001
100
2.5
3
1.0
0.0
0
0.0, 0.0, 0,0...
0.0, 0.0, 0,0...
1.0, 1.0, 1.0, 1.0...
–3.0
+3.0
0
0.0, 0.0, 0,0...
0.0, 0.0, 0,0...
Default Values
1.0
0.0
–100.0
+100.0
0.0
36