Advertisement
Installation
3
Cut out the mounting template on
page 12 (or 13) of this manual, and
tape it to the front of the machine
panel at the desired location. The
large circles on the template
indicated the appropriate card-swipe
orientation (RIGHT, LEFT, TOP, or
BOTTOM).
Please ensure that the 3/16" hole
locations are level.
Drill the 4 3/16" mounting
4
holes and the 7/8" cable
access hole. After drilling,
use a file to de-burr the
holes. Especially the 7/8"
cable access hole.
5
DOC-WR-SPIN-INST
From inside the
machine panel, feed
the J1 connector of the
AYS-050-6-021 cable
through the 7/8" cable
access hole.
If the SPIN is being FLAT mounted, proceed
directly to STEP 9.
www.heartlandMicroPayments.com
5
Advertisement
