Hach SC1000 Instruction Sheet page 3

Modified strain relief installation
1 Mounting panel
2 Extension cable (maximum 15 feet)
3 Lock nut (probe module side)
4 O-ring (Cat. No. 5H1017)
1. Thread the O-ring (Figure
2. Install the strain relief fitting into the panel pass-through hole. On the probe module
side of the panel, thread the lock nut
hand-tighten.
3. Thread the extension cable through the strain relief
4. Install the bushing (Figure
in Figure 2.
5. At the clamping fingers
push the bushing into place in the strain relief.
6. Thread the nut (Figure
strain relief.
7. Connect the extension cable to the display module cable and the probe module.
Figure 2 Instrument components
2, item 4) onto the strain relief body.
(Figure 2, item 3) onto the strain relief and
2, item 6) onto the extension cable. Note the orientation
(Figure 2, item 5), rotate the bushing counter-clockwise and
2, item 7) onto the extension cable and hand-tighten onto the
5 Clamping fingers
6 Bushing (split)
7 Lock nut (display module side)
8 Panel mount bracket
sc1000 Panel Mount Bracket
(Figure 2, item 2).
3