Installation Of Remote Control Batteries - Ricoh PJ WXC4660 User Manual

Introduction

Installation of Remote Control Batteries

Push the clip
1
to release the
battery cover.
For safe operation, note the following precautions:
■
Use two AAA/R03 or LR03 batteries.
■
Keep the remote control away from water or other liquid.
■
Do not place the remote control in an overly hot or humid place.
■
Do not drop the remote control.
■
Do not use a new battery and a used one at the same time.
■
Using a different battery than specifi ed in this manual may cause an explosion.
■
Handle used batteries according to instructions on the battery or local regulations or guide.
■
Remove the batteries when the remote control will not be used for a long time.
■
An infrared remote control may not work if it is exposed to strong light or fl uorescent light.
■
If battery liquid leaks in the remote control, carefully clean the battery holder before
installing new batteries.
■
Keep batteries out of the reach of children. (Children may swallow or choke on the
batteries. If this happens, contact a doctor immediately.)
24
English
Install new batteries (AAA/
2
R03 or LR03). Ensure that you
have the batteries' polarity
(+/–) aligned correctly
Close the battery
3
cover and press it
down until it clicks
into place. Do not
.
mix different types of
batteries or new and
old batteries.