Titan TX200S Manual page 6

Needle Jet
Step 4
:
Finish building the carburetor
Step four; now thread the throttle cable through
the top of your cap and out through the slide. The
slide will have an opening at the bottom. Once
the cable is through the slide grab your wire stop
and thread the cable through the wire stop and
then adjust the tightness of the cable with the
screw on top of the wire stop. Now it's time to
thread the spring in threw your wire cable. To do
this, take the end piece of the spring and open it
slightly so that you can twist on the spring on to
the cable.
GokartsUSA.com HPO High Performance Option Installation Honda GX, Titan TX200S 6