Whirlpool WRX-17TM Service Manual page 25

15- On the right, law the cable under the end cap housing;
16- While in the opposite side, disconnect the hidden cables, keeping the male connector outside and the
female connector inside the end cap housing;
17- Close the end caps housing, reassembling the finishing plastic cover (in the right side) and the plastic cover
& bushing (in the left side);
18- At the lower part, remove the right-hand clicking bushing and install the left-hand clicking bushing which is
available on the Kit;
19- On the left-hand side, remove the bushing and place it in the opposite side where the right-hand bushing
was installed;
20- Repeat the same procedure indicated above for the refrigerator door;
21- Position the refrigerator door, check for its alignment and then fasten the intermediary hinge;
25