Table of Contents
Advertisement
3. Now insert one of the wiring cable into the connector;
4. Then insert one of the sensor wires into the same connector;
5. Using a pliers, press the connector blade. Internally, this blade will lock both wires doing the electrical
connection between them.
Important: Only press the metal blade after ensuring that the wires are touching the connector bottom. Do not
remove the silicon grease from inside the connector, for this grease protects the wire terminals against moisture
and rust.
6. Take the other connector and repeat the operation with the other wires, then put the Sensor at its origin
position.
7.7. Door Reversal
This Refrigerator comes assembled from the factory, with the doors opening towards the right side (hinges and
bushings are located on the right side, when facing the product).
In order to change the doors opening, that is, to cause it to open towards the left side, the specific left-hand
clicking bushings (refrigerator & freezer door) and centre hinge for reversal should be replaced and the below
steps followed.
Wires touching the
connector bottom
22
Hide quick links:
Advertisement
Table of Contents
