Whirlpool WRX-17TM Service Manual page 23

Note: The right clicking bushings and centre hinge, initially assembled on the product, will not be used any
longer. The upper and lower hinges remain the same, so there is no need to replace them.
1- Disconnect the product from the power outlet;
2- Remove all door shelves (freezer & refrigerator) to prevent them from falling during the procedure;
3- Using screwdriver, remove the upper hinge cover;
4- Disconnect the Interface board (LCD Display) wire connectors;
5- Remove the upper Hinge screws and then the Hinge itself;
6- Remove the freezer door;
7- Hide the wire connector into the cabinet housing, then remove the plastic cover from left side and place it on
the right-hand;
8- On the left side of the cabinet, release the hidden wire connectors, then, disconnect them keeping the
female connector outside to plug it later on at the freezer Door connector;
Note: The male connector must be kept inside of the cabinet housing
23