Remote Control - Sansui HDLCD1900A Owner's Manual

Remote control
1
2
3
4
5
6
8
9
10
11
12
13
14
15
16
1. POWER Button - Used to turn the power on/off to
the LCD -IV.
2.SLEEP Button -To set the LCD -IV to turn off
after a preset amount of time, use the SLEEP
button on the remote control.
3. Direct Channel Selection Buttons (0-9) - Allows
direct access to any channel of the LCD -IV.
4.- Button -This button is the "-" button used
when selecting digital channels. Also can display
the current channel number when viewing the
program.
5. RESET Button - Press to reset the On-Screen
picture adjustments to their factory preset positions.
To use this function, select "Picture" or "Audio" in
the menu screen, then press this button.
6.CH (CHANNEL) +/-/CURSOR • / • Buttons
- Used to operate the menu functions of the LCD
TV, and to change the channels of the LCD TV.
7. MENU Button - Use to display the On-Screen
menu function.
8. MUTE Button - To turn off the sound, press this
button once. The LCD TV will be silenced and
the symbol "Mute" will appear on the screen. The
muting feature can be released by pressing the
MUTE button again or one of the VOL (VOLUME)
+ or - buttons.
9. DISPLAY Button - When you press this button,
the current information will be displayed on a
screen. To remove the display from the screen,
press this button again.
10. PICTURE SIZE Button - Used to change the
picture size.
11. INPUT SELECT Button - Use to change the
external input.
12. RECALL Button -This button allows you to go
back to the previous channel selected by just
pressing the RECALL button. Press this button
again to return to the channel you were watching.
13. CCD Button - Used to display the Closed Caption
menu screen.
14. ENTER Button - Use to enter or select
information for On-Screen operations. Also can
display the current channel number when viewing
the program.
15.VOL (VOLUME) + / -/CURSOR • / I_ Buttons
- Used to operate the menu functions of the LCD
TV. Press the _ button to increase, or the • button
to decrease the sound level.
16. EXIT Button - Press to remove setup menu.
Before using the remote control, batteries must first be installed.
HOW TO INSTALL BATTERIES
1. Open the battery compartment cover.
.Y
2. Install two "AA" batteries (supplied).
3. Replace the battery compartment cover.
Use two "AA" size batteries. The batteries may last
approximately one year depending on how much the
remote control is used. For best performance, it is
recommended that batteries should be replaced on a
yearly basis, or when the remote operation becomes
erratic. Do not mix old and new batteries or different
types.
BATTERY PRECAUTIONS
These precautions should be followed when using
batteries in this device:
• Use only the size and type of batteries specified.
• Be sure to follow the correct polarity when
installing the batteries as indicated in the battery
compartment. Reversed batteries may cause
damage to the device.
• Do not mix different types of batteries together (e.g.
Alkaline and Carbon-zinc) or old batteries with fresh
ones.
• If the device is not to be used for a long period of
time, remove the batteries to prevent damage or
injury from possible battery leakage.
• Do not try to recharge batteries not intended to be
recharged; they can overheat and rupture. (Follow
battery manufacturer's directions.)
9