Connecting Rod Reaming and
Alignment Checking Fixture
With these precision tools, it's easy to check
connecting
rods
(without
bushings)
for
alignment and warpage.
The
8111A
Base/Retainer Kit is required as
well as one (or more) of the Adapter Kits
described below.
The
8111 A Kit
Includes the
high-carbon steel base (hardened and ground for
long life); retaining collar,
cap
(for connecting
rod) and wing nut.
The 8111A Base/Retainer Kit fits the following
Adapter Kits as described below.
Adapter Kits
These kits contain the indicator gauge assembly,
which as a dial indicator reading in ten-thou-
sandths of an inch
(.0001 ").
The gauge body is
lapped into the mating bushing for accurate
readings. Instructions are included.
Adapter Kits
8042C
for
520-4 70-E
Series
8072C
for
0-200, 0-300,360
1.125"
1.00· & .922"
Reamers, Connecting Rod Bushing
High-speed
steel
reamers with 3/4" diameter
pllot.
Use with
8111A
Base/Retainer Kit and
proper Adapter Kit as shown above.
874-40
874-41
5008
8071
.920"
Roughing
.923"
Finishing
1. 126" Finishing
1.000·
Finishing
use together
2-20
Base/Retainer
Kit
8111A
v~~tf
Complete tool combining
8111 A Base with
one of
the 3
listed adapter
kits
shown
checking rod for alignment.
Complete tool
using
same
adapters
shown above
With
piston
pin reamer.
See at left
for proper reamer to use