Install Lens; Connect Power - Barco UDX series Quick Reference Manual

Hide thumbs Also See for UDX series:

Install Lens

1. Place the primary lens lock in "unlock" position. Handle (ref. 1) towards electrical socket (ref 3).

2. If present, remove the plastic protection cover from the lens holder opening.

3. Check if the secondary lens lock stands in the "ulock" position (ref 2).

4. Gently insert the lens. Ensure the lens connector matches the electrical socket on

the lens holder.

5. Insert the lens until the connector seats into the socket.

- The secondary lens lock (ref. 2) makes an audible clicking sound when latching.

- Do not release the lens holder by sliding the primary lens lock handle into the

"locked" position.

6. Check if the lens touches the front plate of the Lens Holder.

7. Check if the lens is really secured by trying to pull the lens out of the lens holder.

Ensure that the power is properly connected to the

power input. (120-160V* / 200-240V [+/-10%]).

* reduced light output

Start up

1. Power on. Turn the mains switch to on ( I ).

- Startup sequence starts. Backlight of the Power on / o button ﬂashes WHITE.

- When startup sequence is ﬁnalized the Power on / o button will be lit WHITE.

2. Press the Power on / o button.

- The backlight of the Power on / o button changes from WHITE to BLUE.

- local LCD displays a startup screen.

!! ONLY USE TLD+ Zoom Lenses !!

Table of Contents