Resetting The Control Unit After Replacing/Repairing The Engine - KTM 990 Adventure Repair Manual

2-11
1
2
3
4
5

Resetting the control unit after replacing/repairing the engine

NOTE: the control unit must be reset after replacing the engine or after
engine repair if replacing a piston, cylinder or cylinder head.
The engine may have a poor idle behavior if the control unit is not
reset.
– Connect the KTM diagnostics tool, turn the ignition switch on and
start the program.
– Select "Extend" .
1
– Select "Device operation"
– Enter your password.
– Select "All reference reset operation"
window with the arrow
4
– Acknowledge with "Execute"
– Wait until the "Reset" process is completed, exit the program, turn
the ignition switch off and disconnect the KTM diagnostics tool.
– Allow the vehicle to idle for 15 minutes. Do not open the throttle
during this time, observe the coolant temperature, stop if the engine
is likely to overheat.
.
2
and move to the right
3
.
to "Reset" the control unit.
5