Features - Master SilentDrive MH-220T-SDR User's Manual & Operating Instructions

Wheel
Fuel Gauge
1. Insert axle through holes in wheel support.
2. Slide then spacer onto axle.
3. Slide wheel onto axle and hold in place with the
axle nuts. (See Figure 1).
Wheel Support Frame
Tire
Axle Nut
4. Place heater on wheel support frame and line up
holes on the fuel tank lip.
5. Attach front handle with (4) long screws
(50 mm) and (4) nuts through the second and
third hole from the front on both sides of the tank
lip and wheel support frame and tighten firmly.
6. Insert (2) short screws (30 mm) through the first
hole the front of in the tank lip and tighten firmly.
Make certain all (6) screws are secure.
7. Attach rear handle with (4) long screws (50 mm)
and (4) nuts through the first and second hole
from the rear on both sides of the tank lip and
wheel support frame and tighten firmly.
8. Attach front guard with the included hardware.
© 2018 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE

FEATURES

Fuel Cap
ASSEMBLY INSTRUCTIONS
Models: 150T-SDR / 220T-SDR
Axle
Spacer
Figure 1
Shell Control Panel
Fuel Tank
Safety Guard
Figure 2
5
Silent Drive Forced Air Heater User's Manual
Rear Guard
Handle
Power Cord
Support Frame
Drain Bolt
Handle
Wheel Support Frame