Table of Contents
Advertisement
Quick Links
CONSUMER: READ AND SAVE THESE INSTRUCTIONS
IMPORTANT: Read and understand all of the directions in this manual before assembling,
starting, or servicing the heater. Improper use of this heater can cause serious injury. Keep
this manual for future reference. The requirements of local authorities having jurisdiction
shall be followed.
DANGER
of fire, explosion, burn,asphyxiation, and carbon monoxide poisoning can result.
Only persons who can follow and understand these instructions should use or service this
heater. If you need heater information such as an instruction manual, labels, etcetera,
contact the manufacturer.
DANGER
under construction, alteration or repair.
Model Number
MH-400T-KFA
GENERAL HAZARD WARNING: Be sure to comply with the
instructions and warnings provided with this heater, or death,
serious bodily injury and property loss, damage from the hazards
Not for use in residential living areas or in non-adequately ventilated
enclosed spaces. For outdoor use. Indoor use permitted for: The
temporary heating of adequately ventilated buildings or structures
Fax: 320-251-2922 • Web: www.masterindustrialproducts.com • Email: info@pinnacleclimate.com
KEROSENE FORCED AIR
User's Manual &
Operating Instructions
1 Industrial Blvd #101, Sauk Rapids, MN 56379 USA • Toll Free (800) 779-3267
© 2017 Pinnacle Climate Technologies, Inc. MAKB-409
HEATER
Advertisement
Table of Contents
Related Manuals for Master MH-400T-KFA
Summary of Contents for Master MH-400T-KFA
- Page 1 User’s Manual & Operating Instructions Model Number MH-400T-KFA CONSUMER: READ AND SAVE THESE INSTRUCTIONS IMPORTANT: Read and understand all of the directions in this manual before assembling, starting, or servicing the heater. Improper use of this heater can cause serious injury. Keep this manual for future reference.
-
Page 2: Table Of Contents
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE Table of Contents Safety Information Indicates an imminently hazardous DANGER Safety Information ..............2-3 situation which, if not avoided, WILL Features ..................3 result in death or serious injury. Specifications ................ -
Page 3: Safety Information
Lower Shell Fuel Gauge Drain Bolt (Bottom-Front Rear Handle of Fuel Tank) Fan Guard Side Cover Fuel Tank Control Panel Power Cord Figure 1. Features of Model MH-400T-KFA © 2017, Pinnacle Climate Technologies, Inc. Kerosene Forced Air Heater User’s Manual... -
Page 4: Specifications
NOTE: Save the box and packaging materials for future storage. receiving the missing components. Specifications MH-400T-KFA 53" 30" 36" " 3 " 0 Figure 2. Dimensions of Model MH-400T-KFA © 2017, Pinnacle Climate Technologies, Inc. Kerosene Forced Air Heater User’s Manual... -
Page 5: Assembly
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE Assembly Model MH-400T-KFA Wheel Wheels and Axle Wheel Caps Front Handle Cord Wraps Wheels (Pneumatic) Rear Handle Cord Wraps Screws, Nuts, and Washers Cotter Pins and Bushings... -
Page 6: Operation
- Use K-1 kerosene in this heater. A suitable substitute is #1 fuel. Model Internal Shut-off Temp. Reset Temp. +/-10 Degrees +/-10 Degrees MH-400T-KFA 176°F / 80°C 149°F / 65°C Cord Wrap OVERVIEW OF HEATER DESIGN Screw (L) Fuel System: This heater is equipped with an electric magnet... - Page 7 NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE Operation (Continued) VENTILATION TO STOP HEATER Never unplug heater while heater is Risk of indoor air pollution. Use CAUTION CAUTION running. heater only in well ventilated areas. Heater must go through cooling cycle.
-
Page 8: Maintenance
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE Operation (Continued) Maintenance Never service heater while it is WARNING plugged in or while hot! NOTE: USE ORIGINAL EQUIPMENT REPLACEMENT PARTS. Use of third-party or other alternate components will void warranty and may cause unsafe operating conditions. - Page 9 NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE Maintenance (Continued) PHOTOCELL CLEAN PHOTOCELL ANNUALLY OR AS NEEDED. Nozzle 1. Remove upper shell. 2. Remove fan (see FAN BLADES, page 8). 3. Remove photocell from its mounting bracket 4.
- Page 10 NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE Maintenance (Continued) FUEL FILTER 6. Stop heater (see OPERATION, page 7). CLEAN TWICE PER HEATING SEASON OR AS NEEDED. 7. If accessory pressure gauge is being used, remove pressure gauge.
-
Page 11: Wiring Diagram
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE Maintenance (Continued) AIR BLEED DIRECTIONS (Continued) 3. Allow the heater to attempt ignition for 3-5 seconds, during which time you may hear a loud “grinding” or vibration sound. 4. -
Page 12: Exploded View
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE Exploded View © 2017, Pinnacle Climate Technologies, Inc. Kerosene Forced Air Heater User’s Manual... -
Page 13: Parts List
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE Parts List Description MH-400T-KFA PCB Assembly 70-027-0800 Fuel Cap Assembly 70-006-0200 Pneumatic Wheel 70-041-0110 Photocell 70-016-0150 Nozzle 70-015-0750 Fan Assembly 70-024-0700 © 2017, Pinnacle Climate Technologies, Inc. -
Page 14: Troubleshooting Guide
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE Troubleshooting Guide Problem Possible Cause Solution Heater Ignites, but main PCB shuts 1. Incorrect pump pressure. 1. Adjust pump pressure (see page 10). off after a short period of time. 2. -
Page 15: Limited Warranty
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE Limited Warranty Pinnacle Climate Technologies, Inc. warrants this heater If Pinnacle Climate Technologies, Inc. finds the item to to the original retail purchaser only, to be free from defects be in normal operating condition, or not defective the item in material and workmanship for a period of one (1) year will be returned freight collect.