Scod" Parameter; Defs" Parameter; Serv" Menu - Level Pro ITC 250 SERIES User Manual

250 SERIES
Loop Powered Display

7.3.4. "Scod" parameter

This parameter defines user password (4-digits number). If this parameter is set at value "0000", user
password is turned off.
If the user do not remember his password, the access to the menu is possible by the "one-use
password". To get this password please contact with Marketing Division. "Single use password"
can be used only one time, after that it is destroyed. Entering this password causes in clearing of
user password, it means sets the user password to "0000".
The "one-use password" can be used ONE TIME ONLY, it is impossible to use it again! The "one-use
password" can be restored by Service Division only.

7.3.5. " dEFS" parameter

This setting allows to restore the factory settings of the device. To get the access to this option
special password is required: "5465", next the device displays acknowledge question "SEt?". Press
[ENTER] to acknowledge the restoring of factory settings or [ESC] to cancel.

7.3.6. "SErv" menu

This menu contains the parameters for authorized service only. To enter this menu proper service
password must be entered. Improper settings can causes of damage of the device.
16