Table of Contents
Advertisement
Installation
1.
Disconnect the DC input power terminal block connector from
your QuickPanel Control unit before inserting the
communication module.
2.
Open the back cover.
3.
Attach the communication module to the unit by plugging the
module into the mating connectors on the back of the unit.
Caution:
4.
Install the three screws to secure the card in the unit.
5.
Close the cover.
Note:
To use this card with QuickPanel Control, Proficy
Machine Edition software is required.
Please refer to the GE Intelligent Platforms Support web
page
upgrades and specials.
GFK-2299
Be sure to properly align pins in the dual
connector upon insertion to avoid damage to
the card or the QuickPanel Control unit.
www.ge-ip.com/support
for the latest service pack
VersaMax Expansion I/O Interface Card
5
TM
Advertisement
Chapters
Table of Contents
