Table of Contents
Advertisement
NO
ITEMS
A STATIC LAOD OF 19.6N USING A R0.5 SCRATCH
TOLL SHALL BE APPLIED ON THE CORE OF THE
COMPONENT AND IN THE DIRECTION OF THE ARROW
AND HOLD FOR 5 SEC. THE TEST BOARD SHALL BE
IEC 40(S)541. HOWEVER THE BASE MATERIAL SHALL
BE G-10 or FR-4 (ANSI GRADE)
ADHESION
(ELECTRODE
10
PEELING
STRENGTH)
A ROD OF 9.8N USING A R0.5 PRESSURE ROD SHALL
BE APPLIED TH THE CENTER IN THE DIRECTION OF
THE ARROW AND HOLD FOR 10 SEC
CORE BODY
11
STRENGTH
TEST CONDITION
Scratch tool
R0.5
Chip
Pressure
W
L
L ＞ W
PERFORMANCE
THERE SHALL BE NO
EVIDENCE OF
MECHANICAL DAMAGE.
ELECTRICAL
CHARACTERISTICS
SHALL SATISFY THE
INITIAL REQUIREMENT.
Board
IF THERE ARE
ELECTRODES ON BOTH
SURFACES, IT SHALL
SATISFY THE ABOVE
REQUIREMENT ON
WHICHEVER SURFACE
IT MAY BE FIXATED ON.
Chip
THERE SHALL BE NO
EVIDENCE OF
MECHANICAL DAMAGE.
ELECTRICAL
CHARACTERISTICS
SHALL SATISFY THE
R0.5
INITIAL REQUIREMENT.
Chip
0.5L
Advertisement
Table of Contents
