Connecting The Video Out To Tv - Samsung HT-XQ100 Instruction Manual

age 18
ss receiving module (SWA-3000)
s Communication
occurs, or if the Link indicator (blue LED) on the wireless receiver does
blinks on the main unit's display.
e wireless receiver module (SWA-3000) are in Power Standby mode.
ress and
AIN button
indicator lights
second.)
ule
or a pair
WIRELESS RECEIVER MODULE
T button
l of the
.
module is lit
eat Steps 1 to
ng is complete, no audio signal is output from the Rear Speaker OUT ports on the back
o the wireless receiver module. Keep the unit away from water and moisture.
ure that the area around the wireless receiver module location is clear of any obstruc-
r speakers in DVD 5.1-CH or Dolby Pro Logic II mode only.
m the wireless rear speakers.
rear of the listening position. If the wireless receiver module is too close to the main
rd due to interference.
oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the same
e sound interruption may be heard due to interference.
s about 33 feet, but may vary depending on your operating environment.
between the main unit and the wireless receiver module, the system may not operate at
ate metal.

Connecting the Video Out to TV

Choose one of the three methods for connecting to a TV.
METHOD2
METHOD 3
METHOD 1 .......
Composite Video (Good Quality)
- Connect the supplied video cable from the VIDEO OUTjack on the side panel of the system to the
VIDEO IN jack on your TV.
METHOD 2 .......
Component (Better Quality)
- If your television is equipped with Component Video inputs, connect a component video cable
(not supplied) from the Pr, Pb and Yjacks on the side panel of the system to the corresponding
jacks on your TV.
METHOD 3 .......
HDMI (Best Quality)
- Connect the HDMI out to the HDMI input on your TV.
•
This product operates in Progressive scan mode(480p Only ) for Component Output.
Note
•
If the TV only supports a resolution of 576i(480i), the screen may be divided into 2 screens,
or display nothing.
ENG
METHOD 1
(supplied)
TV
16