Table of Contents
Advertisement
Symptom
Not all of the material to
be cut is cut. Some
areas remain uncut.
There are deep cuts
completely through the
mat.
The material to be cut is
not cleanly cut.
Possible Causes (or Results)
A blade appropriate for the material
being cut is not used.
If cutting is not possible even
though the cutting pressure is set
higher than necessary, the blade
may be chipped.
The mat's adhesive strength has
decreased, or the material is not
secured.
The blade is worn.
The material is incompatible with
this machine.
The cutting pressure ("Cut
Pressure") is incorrect.
Dust or lint has accumulated in the
holder.
The spacing between arranged
patterns is too small.
The material extends from the
adhesive area of the mat.
Fabric was cut without using a
sheet for fabric cutting.
A fabric is not firmly attached to a
mat that has a high tack adhesive
fabric support sheet on its
adhesive side.
An iron-on fabric appliqué contact
sheet is not firmly attached to a
fabric.
The cutting pressure ("Cut
Pressure") is incorrect.
After using a mat with deep cut
marks which completely went
through the mat, the machine's
surface where the blade points
down (a) has cut marks.
Solutions
Use a blade appropriate for the material
being cut.
Replace the blade with a new one.
Replace the mat with a new one.
Replace the blade with a new one.
Replace the material with one
compatible with this machine.
Adjust the setting for "Cut Pressure" in
the settings screen.
Clean the holder.
Rearrange the patterns to slightly
separate them.
Set the number to "3" or higher in the
"Pattern Interval" setting, and then
rearrange the patterns or perform the
auto layout function.
Attach the material while keeping it
within the adhesive area of the mat.
Attach a high tack adhesive fabric
support sheet to a mat or affix an iron-on
fabric appliqué contact sheet to a fabric
before cutting it.
Firmly attach the fabric to the mat
pressing the handle of the included
spatula across the surface of the fabric.
Iron the entire contact sheet to affix it
firmly to the wrong side of the fabric.
Adjust the setting for "Cut Pressure" in
the settings screen.
Contact the retailer who sold you this
machine or the nearest authorized
service center.
a
Reference
page 23
page 87
page 87
page 87
page 14
page 10
page 27
page 89
page 10
5
page 49
page 16
page 17
page 20
page 20
page 17
page 10
page 27
—
97
Advertisement
Table of Contents
