Roche ACCU-CHEK mobile User Manual

C
ACCU-CHEK, ACCU-CHEK MOBILE, ACCU-CHEK SMART PIX, ACCU-CHEK 360°,
ACCU-CHEK CONNECT and FASTCLIX are trademarks of Roche.
CONTINUA, the CONTINUA logos and CONTINUA CERTIFIEd are trademarks,
service marks or certification marks of the Continua Health Alliance.
CONTINUA is a registered trademark in some, but not all countries in which
this product is distributed.
The USB-IF logos are trademarks of Universal Serial Bus Implementers
Forum, Inc.
© 2017 Roche diabetes Care
Roche diabetes Care GmbH
M
Sandhofer Strasse 116
68305 Mannheim, Germany
www.accu-chek.com
User's Manual and Quick
Start Guide
Blood glucose monitoring system
W
IMPORTANT INFORMATION ON PERFORMING A BLOOD GLUCOSE TEST
An incorrectly performed blood glucose test may lead to incorrect test results which can cause the wrong therapy recommendation to be made and thus produce serious
adverse health effects. Therefore, read the information on how to perform a blood glucose test correctly, carefully.
Do
Before testing your blood glucose: Wash your hands
e n h s c w a _ e d n e a H
with soap and warm water; rinse well to remove any
visible or invisible signs of glucose residue from, for
1
example, food or drink. dry your hands thoroughly
with a clean towel.
Always use a fresh, well-formed blood drop and
perform the test as quickly as possible after lancing.
2
When performing the test, place your finger gently on
the guidance tabs so that only the blood drop
comes into contact with the centre of the test area.
3
Your finger should not make any contact with the test
area. Keep your finger as still as possible.
When the beep tone sounds and Test in progress is
IMMEDIATELY!
displayed on the screen, remove your finger from the
test cassette immediately.
4
Note: You can only hear the beep tones when they
are turned on. See Setting tones in the User's
Manual.
Do not
Why
do not perform a blood
An incorrectly performed blood
glucose test if the testing
glucose test may lead to falsely
site has not been washed or
elevated blood glucose results
is soiled or sticky (for
and thereby delivery of an
example, due to glucose
inappropriately high insulin
residue from, for example,
amount. Falsely elevated test
food or drink).
results are caused by the
following:
• Fingers have not been washed
Do not delay applying the
or were soiled or sticky.
blood drop to the test area.
• If the blood drop spreads on
do not perform a blood
the finger or if the blood drop
glucose test with a smeared
becomes smeared on the test
or spread blood drop. do not
area, the risk of contamination
smear the blood drop on the
of the test area increases
test area.
(for example, due to glucose
residue from, for example,
food or drink).
do not attempt to force your
• The finger was pressed onto
finger between the guidance
the test area.
tabs or apply any direct
pressure to the test area. • Trembling or shaky
Avoid trembling or shaky 1
movements while performing
movements. the blood glucose test.
2
• The blood glucose test was
3
not performed immediately or
4
the finger was resting on the
DO NOT WAIT! do not keep your finger on guidance tabs for too long.
5
the guidance tabs or apply Pay attention to the beep tone.
pressure to the test area The beep tone helps you to
6
after the beep tone sounds obtain a reliable test result.
and/or Test in progress is
7
displayed on the screen.
W
The meter and finger
pricker are intended for
personal use only!
Quick Start Guide
They may only be used by
one and the same person
for performing a blood
Start Here
glucose test. There is a risk
of infections being
transmitted if the meter or
finger pricker is used by
other people, even by family
members, or if healthcare
professionals use this meter
to test blood glucose or this
1
finger pricker to obtain
blood from different people.
e
This Quick Start Guide does
0
not replace the detailed
9
2 User's Manual of your
Accu-Chek Mobile blood
3
q
glucose monitoring system.
4
Be sure to comply with the
5
safety information in the
6
r
User's Manual and in the
w package insert of the test
7 cassette.
8
Release button (priming Test area (at the tip of the
8
and pricking) cassette ready for a test)
Power and enter button Lancet drum
9
down/Up buttons Slide button to release
0
the finger pricker
Window showing number
of available lancets Slide button to open the
q
Lever for loading a new cassette compartment
cover
lancet
Rotatable cap for setting Tip cover
w
the penetration depth Test cassette
e
Tip cover closed (below Guidance tabs
r
right: open)