Table of Contents
Advertisement
TROUBLESHOOTING
REPAIR TIPS:
1. Motor and interior access is easier from the RIGHT side of the unit with the unit lying on
its left side.
2. Most troubleshooting can be performed with the front panel OFF allowing for access to
the control panel/circuit board compartment.
3. The use of LOCTITE on the front panel screws and bin holder is recommended.
Problem
POWER BUTTON is not
illuminated
Loud or Uneven agitation
Agitation is
Counterclockwise
(Cutlery is not emerging
from the discharge chute)
(agitation is rough or
loud)
CPICDMOPINST
Possible causes
Fuses on control panel are
blown
No connection of Safety
Shutoff switch
Faulty Safety Shutoff switch
Tub is not balanced
Missing spacers
Page - 11
Solution
Check power cord connection at wall
Check fuse on back of control panel
(open the front of the unit). Replace if
necessary.
Check amp. reading at motor (with
panel removed)
Ensure sound connection between
SAFETY SHUTOFF switch and
machine (back right under the lid of the
machine)
Replace SAFTEY SHUTOFF switch
Ensure that the stainless INOX tub is
sitting on the four (4) chassis springs
Place correctly on springs
Check that the rear two (2) hinges are
tight and secure
Check that the four (4) spacers (2 front
and 2 back) are present thereby lifting
the compartment shroud "off" of the
agitating tub
Turn machine on/off (at the CONTROL
PANEL) several times in succession
Check electrical connection at the
condenser (capacitor) - restart
Remove protective housing at bottom of
motor, ensure counter weights (yellow)
are secure, tight, and in line with each
other. You must remove the front panel
and the right side panel to access the
motor. Restart
Remove motor from housing and check
the unprotected weights (yellow) at the
top of the motor are secure, tight and in
line with each other AND WITH THE
BOTTOM COUNTERWEIGHTS. Re-
attach motor, restart (prior to replacing
panels).
Replace motor
SALES + SERVICE
(905) 829-2355
www.cpishine.com
Hide quick links:
Advertisement
Table of Contents
