How To Switch On The Machine; How To Switch "Off" The Machine - CPI CDM12K Operating Instructions Manual

Silvershine - the cutlery drying machine

Hide thumbs

Table Of Contents

Table of Contents

For your Silvershine machine to perform at peak efficiency, the granulate must be warmed

to properly dry the cutlery. Therefore the dryer needs to be switched on at least 20-30

minutes before use to preheat the granulate until the thermoregulator reads approx.

125°°F .

Proceed as follows to switch ON the machine:

1. Ensure the unit is plugged in.

2. Place a cutlery basket under the delivery chute.

3. Lift the stainless steel lid to check the tank contains the correct

amount of granulate. The granulate level should be approx. 4-

5 cm below the grill. Top up with more granulate, if necessary.

Gently close the lid.

4. Press the "On/Off" button located on the outside of the cutlery

dryer to activate the dryer.

 The button will be illuminated; the granulate and tub will start to vibrate;

 the Thermoregulator located on the control panel will also illuminate indicating that

the heater has been activated.

5. The machine has a safety mechanism built into it so that it will not operate with the

stainless steel lid open. If it does, it means the machine has been tampered with, so

switch it off immediately and call for service. Do not use it until the service centre has

made the necessary repairs.

Remember that the purpose of the granulate found in Silvershine is to dry the cutlery. It

accomplishes this by absorbing moisture found on the cutlery. Therefore when you finish

using the machine, it is advisable to let it run for at least 15 minutes before shutting it off to

allow the granulate to dry out.

Proceed as follows to switch OFF the machine:

Press the "ON/OFF" button located on the front of the machine. The motor will shut

off and the "Nautilus" tub will vibrate more vigorously for a short time before stopping

completely.

1. The light on the "ON/Off" button will go out;

2. the light and digital temperature display on the Thermoregulator will also go out

indicating that the heater has been turned off.

CPICDMOPINST