Advertisement
MOUNTING INSTRUCTIONS
Warning!
It is advisable to have an Öhlins dealer install the shock
absorber.
Warning!
If working on a raised vehicle, ensure it is securely
supported so that it will not tip over.
1
Put the motorcycle on a center stand so that
the rear wheel barely touches the ground.
Make sure the motorcycle is in a stable
position.
2
Remove the fairing on left side. First remove
the screw. Then push the center rivet pin with a
small pin to release it.
3
Loosen the upper and the lower bolts of shock
absorber.
4
Mount the Öhlins shock absorber onto the
motorcycle.
5
Tighten the upper and the lower bolts according
to HONDA service manual.
6
Reload the rivet the side fairing.Push the
center pin back into original position.
7
Remount the left fairing.
Note!
Before mounting this product clean the vehicle
thoroughly.
Note!
When working on this product, always see the Vehicle
Service Manual for vehicle specific procedures and
important data.
8
Retighten the screws on the side fairing
according to HONDA service manual.
9
Lock the rivet by pushing in the center pin.
Note!
Lower the vehicle so that the suspension is slightly
compressed before tightening the screws.
Caution!
Ensure that all screws are tightened to the correct
torque and that nothing fouls or restricts movement
of the shock absorber when the suspension is fully
compressed or extended.
2
Advertisement
