Connecting To A Monitor; Connecting To Power - Samsung SID-452 Instruction Manual

Connection

Connecting to a Monitor

Connect the VIDEO-OUT jack to the VIDEO-IN jack of monitor.
CCTV Camera
• As the connecting method varies with the instruments, refer to the manual
supplied with the instrument.
• If necessary, you can connect the monitor to the REMOTE jack on the back of
your camera.
• Only connect the cable when the power is turned off.
• Set the 75Ω / Hi-Z selection switch as shown below if you have an intermediate
device.
CCTV Camera
18
COLOR DOME CAMERA
Monitor
Intermediate End monitor
User's Manual

Connecting to Power

Connect the adaptor to the power input connector as shown in the figure below.
The recommended adaptor specification for SID-452N/SID-452P is AC24V, 300mA.
When the resistance value of copper wire is at [20°C(68°F)]
2
Copper wire size (AWG) #24(0.22mm ) #22(0.33mm
Resistance (Ω / m) 0.078
Voltage Drop (V/m) 0.028
•As shown in the table above, voltage decreases as the wire gets longer.
Therefore use of an excessively long adaptor output line for connection to the
camera may affect the performance of the camera.
*Standard voltage for camera operation : DC 12V ± 10%
*There may be some deviation in voltage drop depending on the type of wire and the manufacturer.
Notes
• Be sure to connect power only after all the installation is complete.
• Note that AC or DC adaptor is not supplied with camera.
• Use the UL listed, class 2 power transformer of AC 24V adaptor.
• Ground should be connected to the GND terminal.
COLOR DOME CAMERA
2 2 2
) #20(0.52mm ) #18(0.83mm )
0.050 0.030 0.018
0.018 0.011 0.006
19
User's Manual