Table of Contents
Advertisement
4.Safety
B
WARNING
NEVER REMOVE ROPS.
The protection offered by this ROPS will be
impaired if it has been subjected to any
modification, structural damage, or has been
involved in an overturn incident. This ROPS
must be replaced after a rollover. Seat belts
must be worn while operating vehicle.
C
5103008-06-A
D
D
5103008-22-A
E
5103008-15-A
F
IMPORTANT
Use diesel fuel according to one of the following
technical specifications:
EN590
ASTM D975 2D
JIS K 2204
44
ANSI-Style and Common Safety Decal Location
5103008-03-A
WARNING
CRUSH HAZARD
Keep away from machine when it
is being operated.
Lock frames together when
machine is serviced or shipped.
5103008-08-A
WARNING: Do not modify ROPS; replace
damaged ROPS; wear seat belt;
NEVER REMOVE ROPS.
Located inside the ROPS structure.
•
The protection offered by this ROPS will
be impaired if it has been subjected to
any modification, structural damage, or
has been involved in an overturn
incident, this ROPS must be replaced
after a roll-over. Seat belts must be
worn while operating vehicle.
WARNING: Crush Hazard
Located on top of the articulation joint on
both sides.
•
Keep away from machine when it is
being operated.
•
Lock frames together when machine is
serviced or shipped.
USE DIESEL FUEL ONLY!
Located next to the fuel filler neck.
Tie-down point, located on lift arm (front,
both sides) and frame (rear, both sides).
•
Only use tie-down points indicated on
loader when transporting loader.
IMPORTANT
Located next to the fuel filler neck.
•
Use ONLY diesel fuel according to one
of the following technical specifications:
•
EN590
•
ASTM D975 2D
•
JIS K 2204.
See chapter "Maintenance".
Advertisement
Table of Contents
