Table of Contents
Advertisement
4.Safety
must have immediate medical aid. Call the Poison Control Center at 1-800-
222-1222 in the United States.
Fire Hazards
•
The machine must be cleaned on a regular basis to avoid the buildup of flam-
mable debris, such as leaves, straw, etc. Accumulated debris, particularly in
the engine compartment, creates a fire hazard.
•
The machine has several components that operate at high temperatures
under normal operating conditions, primarily the engine and exhaust systems.
Also, the electrical system, if not properly maintained or if damaged, can arc or
produce sparks. These conditions make it extremely important to avoid cir-
cumstances where explosive dust or gases can be ignited by arcs, sparks or
heat.
•
Add fuel, oil, antifreeze and hydraulic fluid to the machine only in well-venti-
lated areas. The machine must be parked with controls, lights and switches
turned off. The engine must be turned off before fueling.
•
Do not smoke while filling the fuel tank, while working on the fuel or hydraulic
systems, or while working around the battery.
•
Take care to avoid spilling combustible fluids, such as oil or fuel, on a hot
engine.
•
Static electricity can produce dangerous sparks at the fuel-filling nozzle. In
very cold, dry weather or other conditions that could produce static discharge,
keep the tip of the fuel nozzle in constant contact with the fuel filler neck, to
provide a ground. Be sure that a ground wire is connected from the machine to
the service truck before fueling begins.
•
Keep fuel and other fluid reservoir caps tight and do not start the engine until
caps have been secured.
•
It is recommended that a 2.27 kg (5 lbs.) or larger, multi-purpose "A/B/C" fire
extinguisher be mounted within reach of the operator. Check the fire extin-
guisher periodically and be sure that work site crew members are trained in its
use.
•
Oil leaks can ignite on hot components. Repair any damaged or leaking com-
ponents before using machine.
Transporting the Machine
Obey federal, state and local over-the-road regulations. Check restrictions
regarding weight, height, width and length of a load. The hauling vehicle, trailer
and load must all be in compliance with applicable regulations (see chapter
"Commissioning").
38
Advertisement
Table of Contents
