4.Safety
During Operation
•
ALWAYS fasten the seat belt securely and properly. Never operate the
machine without the seat belt fastened around the operator.
•
Check indicators and displays for normal conditions after starting the engine.
Listen for unusual sounds and remain alert for other potentially hazardous
conditions.
•
Control the machine cautiously and gradually until fully familiar with all the
controls and handling.
•
Do not overload the machine. See chapter "Technical data".
•
Do not raise or drop a loaded bucket or attachment suddenly. Abrupt move-
ments under load can cause serious instability.
•
Check that attachments are securely fastened to the attachment hitch before
working.
•
Never activate the float function with the bucket or attachment loaded or
raised, because this will cause the lift arm to lower or bucket to dump rapidly.
•
Never operate the machine without a ROPS or FOPS installed.Machine stabil-
ity is affected by: the weight of the load being carried, height of the load,
machine speed, turn angle, width of the machine across the tires, abrupt con-
trol movements and driving over uneven terrain.
WARNING
MACHINE, RESULTING IN DEATH OR SERIOUS INJURY.
Therefore: ALWAYS operate with the seat belt fastened around the operator.
•
Do not exceed the machine's rated operating capacity; see chapter "Technical
data". Be aware that effective operating capacity is reduced when the machine
is turned.
•
Machine stability is reduced when the machine is turned.
•
Be aware that attachments effect the handling and balance of the machine.
Adjust the operation of the machine as necessary when using attachments.
•
Carry the load low. Move the controls smoothly and gradually, and operate at
speeds appropriate for the conditions.
•
Do not use the machine to lift or transport people. Do not allow others to ride
on the machine or attachments, because they could fall or cause an accident.
•
Always look to the rear, over both shoulders, before backing up.
•
Only start the engine while seated in the operator's seat with the seat belt fas-
tened around the operator.
•
Only operate the controls while seated in the operator's seat with the seat belt
properly fastened.
•
Always keep hands and feet inside the operator's compartment while operat-
ing the machine.
32
DISREGARDING ANY OF THESE FACTORS
CAN CAUSE THE MACHINE TO TIP, THROWING
THE OPERATOR OUT OF THE SEAT OR